Filter
Top Products
CyberPower Network Management System
3
In this section, it will be introducing the “SNMP Card Configuration Tool” program.
If a DHCP network service is not available or you want to assign a new IP Address to the SNMP
card, please follow the steps listed below:
I. IP setup using “SNMP Card Configuration Tool” program:
1. Please run the “wsnmpcfg” program in the “All Programs”->“SNMP Card Configuration Tool”.
2. The main dialog of the “SNMP Card Configuration Tool” program is shown as Figure. 2. The
User can obtain information of the SNMP card through the GUI.
3. The "Refresh" button is used to search the entire SNMP card device in local network.
Figure 2. The main dialog of the “SNMP Card Configuration Tool” program.
4. Then choose the 「Setup as selected」 under 「Tool」 menu or double click the SNMP card
device.
5. You can modify the new IP, new subnet mask, and new gateway address through the IP or
MAC address in the SNMP card setting dialog, as shown in figure 3.
Figure 3. The SNMP card setting dialog.