Filter
Top Products
Installation
•
11
2.4 Hardware Installation
PCI configuration
The PCI cards are equipped with a plug and play PCI controller,
it can request base addresses and interrupts in accordance with the PCI
standard. The system BIOS will install the system resource based on the
PCI cards’ configuration registers and system parameters (which are set
by system BIOS). Interrupt assignment and memory usage (I/O port
locations) of the PCI cards can be assigned by system BIOS only. These
system resource assignments are done on a board-by-board basis. It is
not suggested to assign the system resource by any other methods.
PCI slot selection
The PCI card can be inserted to any PCI slot without any configuration for
system resource. Please note that the PCI system board and slot must
provide bus -mastering capability to operate this board properly.
PCI Installation Procedures
1. Turn off your computer
2. Turn off all accessories (printer, modem, monitor, etc.) connected to
your computer.
3. Remove the cover from your computer.
4. Set up jumpers on the PCI card.
5. Select a 32-bit PCI slot. PCI slots are shorter than ISA or EISA slots, and
are usually white or ivory.
6. Before handling the PCI cards, discharge any static buildup on your
body by touching the metal case of the computer. Hold the edge and do
not touch the components.
7. Position the board into the PCI slot you selected.
8. Secure the card in place at the rear panel of the system.