Filter
Top Products
ADVANCE
CY14E102L, CY14E102N
Document Number: 001-45755 Rev. *A Page 10 of 21
AutoStore and Power Up RECALL
Parameters Description
CY14E102L/CY14E102N
Unit
Min Max
t
HRECALL
[16]
Power Up RECALL Duration 20 ms
t
STORE
[17]
STORE Cycle Duration 15 ms
V
SWITCH
Low Voltage Trigger Level 4.4 V
t
VCCRISE
VCC Rise Time 150 μs
Software Controlled STORE and RECALL Cycle
The following table lists the software controlled STORE and RECALL cycle parameters.
[18, 19]
Parameters Description
15ns 20 ns 25ns 45ns
Unit
Min Max Min Max Min Max Min Max
t
RC
STORE and RECALL Initiation Cycle Time 15 20 25 45 ns
t
AS
Address Setup Time 0 0 0 0 ns
t
CW
Clock Pulse Width 12 15 20 30 ns
t
GHAX
Address Hold Time 1 1 1 1 ns
t
RECALL
RECALL Duration 200 200 200 200 μs
t
SS
[20, 21]
Soft Sequence Processing Time 70 70 70 70 μs
Hardware STORE Cycle
Parameters Description
CY14E102L/CY14E102N
Unit
Min Max
t
DELAY
[22]
Time allowed to complete SRAM cycle 1 70 μs
t
HLHX
Hardware STORE pulse width 15 ns
Notes
16.t
HRECALL
starts from the time V
CC
rises above V
SWITCH.
17.If an SRAM Write has not taken place since the last nonvolatile cycle, no STORE takes place.
18.The software sequence is clocked with CE
controlled or OE controlled reads.
19.The six consecutive addresses must be read in the order listed in the mode selection table. WE
must be HIGH during all six consecutive cycles.
20.This is the amount of time it takes to take action on a soft sequence command.Vcc power must remain HIGH to effectively register command.
21.Commands such as STORE and RECALL lock out IO until operation is complete which further increases this time. See the specific command
.
22.On a hardware STORE initiation, SRAM operation continues to be enabled for time t
DELAY
to allow read and write cycles to complete.
[+] Feedback