Filter
Top Products
CY8C21634, CY8C21534
CY8C21434, CY8C21334, CY8C21234
Document Number: 38-12025 Rev. *O Page 32 of 45
AC I
2
C Specifications
The following tables list the guaranteed maximum and minimum specifications for the voltage and temperature ranges: 4.75V to 5.25V
and -40°C ≤ T
A
≤ 85°C, 3.0V to 3.6V and -40°C ≤ T
A
≤ 85°C, or 2.4V to 3.0V and -40°C ≤ T
A
≤ 85°C, respectively. Typical parameters
apply to 5V, 3.3V, or 2.7V at 25°C and are for design guidance only.
T
WRITE
Flash Block Write Time – 30 – ms
T
DSCLK
Data Out Delay from Falling Edge of SCLK – – 45 ns 3.6 < Vdd
T
DSCLK3
Data Out Delay from Falling Edge of SCLK – – 50 ns 3.0 ≤ Vdd ≤ 3.6
T
DSCLK2
Data Out Delay from Falling Edge of SCLK – – 70 ns 2.4 ≤ Vdd ≤ 3.0
Table 37. AC Programming Specifications (continued)
Symbol Description Min Typ Max Units Notes
Table 38. AC Characteristics of the I
2
C SDA and SCL Pins for Vdd ≥ 3.0V
Symbol Description
Standard Mode Fast Mode
Units
Min Max Min Max
F
SCLI2C
SCL Clock Frequency 0 100 0 400 kHz
T
HDSTAI2C
Hold Time (repeated) START Condition.
After this period, the first clock pulse is
generated.
4.0
–0.6– μs
T
LOWI2C
LOW Period of the SCL Clock 4.7 –1.3– μs
T
HIGHI2C
HIGH Period of the SCL Clock 4.0 –0.6– μs
T
SUSTAI2C
Set-up Time for a Repeated START
Condition
4.7 –0.6– μs
T
HDDATI2C
Data Hold Time 0 –0– μs
T
SUDATI2C
Data Set-up Time 250 – 100
[21]
–ns
T
SUSTOI2C
Set-up Time for STOP Condition 4.0 –0.6– μs
T
BUFI2C
Bus Free Time Between a STOP and START
Condition
4.7 –1.3– μs
T
SPI2C
Pulse Width of spikes are suppressed by the
input filter.
– – 0 50 ns
Note
21.A Fast-Mode I2C-bus device may be used in a Standard-Mode I2C-bus system, but the requirement t
SU;DAT
≥ 250 ns must then be met. This is automatically
the case if the device does not stretch the LOW period of the SCL signal. If such device does stretch the LOW period of the SCL signal, it must output the next
data bit to the SDA line t
rmax
+ t
SU;DAT
= 1000 + 250 = 1250 ns (according to the Standard-Mode I2C-bus specification) before the SCL line is released.
[+] Feedback