Filter
Top Products
6
Power IC, Transistor or Devices Removal/Replacement
1. Heat and remove all solders from the device leads.
2. Remove the heatsink mounting screw (if applicable).
3. Carefully remove the device from the circuit board.
4. Insert new device in circuit board.
5. Solder each device lead, and clip off excess lead.
6. Replace heatsink.
Diode Removal/Replacement
1. Remove defective diode by clipping its leads as close as possible to diode body.
2. Bend the two remaining leads perpendicularly to the circuit board.
3. Observing diode polarity, wrap each lead out of the new diode around the corresponding lead on the circuit
board.
4. Securely crimp each connection and solder it.
5. Inspect the solder joints of the two “original” leads on the circuit board copper side. If they are not shiny, reheat
them and apply additional solder if necessary.
TECHNICAL INFORMATION
Picture Tube
Type : 17-inch, Flat Square Tube type
(16.2-inch, viewing area)
Dot Pitch : 0.28mm
Face Treatment : Non-glare / Anti-static
Video
Input Signal : R.G.B Analog
Amp. Bandwidth : 85 MHz
Input Sync : TTL, separate negative / positive
Scan Frequency
Horizontal : 30-69 KHz
Vertical : 50-160 Hz
Max. Resolution
1280 dots X 1024 lines (at 60Hz)
Power Source
Free Voltage (100-240 Vac, 50/60Hz)
Display Area
Standard Display Area : 310mm(H)X232mm(V)
Full Screen Size : 330mm(H)X250mm(V)
Power Consumption
Max. 100W
Dimension
424(W)X440(H)X447.2(D)mm
(set with stand)
Weight (Net/Gross)
16.8/19.7 kg
Operating Environment
Temperature : 10-40°C/50-104°F
Relative Humidity : 8-80%
Storage Environment
Temperature : -20-45°C/-4-113°F
Relative Humidity : 5-90%
State Recovery Time Power LED
On None Green
Stand-by
3 seconds
Green : 1 second
Suspend Amber : 0.5 second
Off 7 seconds Amber