Filter
Top Products
2
MAN #650360
SETUP:
To enter setup, press and hold the switch (for systems with 3 switches, hold the center switch) while turning on the
key. The display will read “SETUP”. Release the switch and the setup menu will be entered. Below is an outline of
the setup options. Following the outline are more detailed instructions for each option.
Press and release the switch to move through the various setup options or to change a setting.
Press and hold the switch to select a setup option or to save a changed setting.
SETUP
CONTRAST Allows adjustment of LCD contrast.
VERSION Displays software version
UPDATE SPD Sets update speed of fast changing displayed data (such as tachometer)
SLOW Slowest update speed of data
MED Medium update speed
FAST Fastest update speed
TEMP UNIT Selects unit used for temperature displays
F or C Fahrenheit or Celsius
SCREENS Allows turning different display screens on or off
SET DEFAULTS Sets all the settings back to factory default values
DONE Leaves setup and returns to normal operation.
CONTRAST:
This option allows adjustment of the display contrast to best suit the particular mounting location in your vehicle.
Enter setup.
Press and release switch until “CONTRAST” is displayed, then press and hold switch
“CONTRAST” will display with a contrast bar below it.
Press and hold the switch to increase the contrast.
Release the switch and press and hold again to reduce the contrast.
Each time the switch is release the direction of contrast adjustment will change.
Once contrast is set stop pressing the switch.
After about 5 seconds without a switch press the contrast setting will be saved and setup will return to the
main menu.
VERSION:
This option will display the version of the software in the display module. This information may be needed if you
are calling for technical assistance.
Enter setup.
Press and release switch until “VERSION” is displayed, then press and hold switch.
The software version will be displayed (example: VER VC01).
Press and release switch to return to main menu.
UPDATE SPD:
This option sets the fastest update speed of screens. The effect will be most noticed when the tachometer screen
is displayed. The fastest setting will allow frequent updates so the reading is more accurate at any given time. Fast
changing readings may be difficult to read or distracting so some customers prefer to read a slower averaged
reading which is available in the MED or SLOW setting. Default setting is MED.
Enter setup.
Press and release switch until “UPDATE SPD” is displayed, then press and hold switch.
Press and release switch to toggle through speed settings.
Press and hold switch when desired setting is displayed to save setting. “DONE” will be displayed.
Release switch to return to main menu.