Filter
Top Products
2Magellan
®
1000i
Optional Stand
An optional stand is available for the scanner which can be
permanently attached to a wall or countertop. After locating the
stand in an optimal position, the scanner (along with the stand)
can be detached for portable use by lifting the entire unit as
shown below.
Power Supply
Models require
1
either a Listed class II or class III with a Limited
Power Source (LPS). For the safety certification to be valid, class
III input power sources must be IEC/EN60950-1 (EN 60335-
series, EN 60065 or relevant) approved.
Input: 100 - 240 VAC Output: 5 - 14 VDC (check scanner voltage option)
Max. Current: 1 A Max. Power: 14 W
How to Scan
Bar codes can be presented to the scanner while it is resting on
the counter or in the optional stand, or the scanner/mount can be
lifted and held as shown.
1. Power Off the Terminal (POT) units do not require a power supply.
*Optional Stand
Switch Option Shown