Datalogic Scanning 1000I Scanner User Manual


 
Quick Reference Guide 1
Quick Reference
This guide is provided to help get your installation up-and-run-
ning quickly and efficiently. For more details, including program-
ming information, reference the Product Reference Guide (PRG),
which is available for viewing and download from the Datalogic
website listed on the back cover of this manual.
Installation
Route the interface cable from the terminal or host. Plug the AC
adapter (if one is used) into a wall outlet and the interface (I/F)
cable, then route and attach the I/F cable to the scanner. Verify
operation by presenting known-good bar codes to the scanner.
The unit should beep
1
and/or flash its good read LED and send
the bar code data to the host or terminal. If not, refer to the Trou-
bleshooting section of this guide.
Scanner installation is complete.
1. Beeper and LED behavior is selectable and may have been disabled
by a previous user.
I/F Cable
Connect
Here
A/C Adapter
(if needed)
For 220-230 VAC
adapters, the
cord must be
facing down as
shown in the
illustration. If
installed upwards,
it will pose an
undue strain on the
socket outlet.
To Host/Terminal