Datalogic Scanning DLL2020-WO Laptop User Manual


 
18 Installing the DLL2020-WO
D) Keyboard Wedge non direct power
For those systems which do not supply electrical power on the
keyboard port, the following set-up is applicable.
Plug the cable with the 10-pin modular jack into the scanner port
until a firm ‘click’ is heard.
Plug the other connector into the splitter box as illustrated in the
figure below. Plug the communication cable with the 8-pin modular
jack into the Keyboard Wedge port of the splitter box. Connect the
female connector at the other end of the cable to the keyboard.
Plug the male connector into the keyboard port of your computer.
Connect the Datalogic power supply unit to the power supply port
of the splitter box. Power on the scanner by connecting the IEC
power cord to the AC/DC power supply and by plugging the AC
power cord into an AC outlet.
Once the scanner has been installed, you can start scanning bar
code labels.
If you want to change the default settings of the scanner, proceed to
the Configuration Guide supplied with the scanner.
Polaris
Cable
Splitter box
Power supply
Communication
cable
KBW
To AC
Power outlet
To keyboard
To computer
Computer
Keyboard Wedge non direct power
DLL2020-WO