Filter
Top Products
ST/SV-3210 and ST/SV-3306 11
To use roll ticket stock, the
stock must be mounted on
the optional Roll Hanger, as
shown. (See Section 6 for
stock requirements.)
þ Note: To use an internal
fanfold ticket source on a
printer equipped with the
Roll Hanger option, first
remove the Roll Hanger by
unscrewing it from the
printer. Store the hanger in
a safe place for future use.
• Loosen the Thumbscrew and adjust the Media Guides to fit the width
of the ticket stock: the guides should be positioned close enough to
stop side-to-side ticket movement, but not so tight to cause friction
or bowing of the ticket stock (see below). Tighten the Thumbscrew
to secure the guides in place.
‘ Slide the ticket stock through the Media Guides. The motor will
start; continue sliding the tickets. The printer will grab the leading
edge of the stock and complete the positioning process. Close the
Access Cover.
þ Notes: If automatic loading doesn’t occur:
1) Ensure that the Printhead Latch is locked.
2) Press the PAUSE button (the On-Line Indicator should be ‘Off’
now).
3) Repeatedly press the F2 button while gently pushing the stock
forward until the printer grabs the ticket.
4) Press the PAUSE button (to return to the on-line mode).
If the ticket was not fed to a proper position, the TOF Sensor may need
adjustment; see Section 4 for details.