Filter
Top Products
40 ST/SV-3210 and ST/SV-3306
If experiencing this problem… Try this solution…
The printer does not print
formats sent from the host, but
the Fault Indicator remains off:
• The parser mode setting between the
printer and host may not match;
reconfigure, see Section 4.3.1.
• The communication parameters between
the printer and host may not match;
reconfigure, see Section 4.3.1.
• The interface connection may be faulty
or the cable may be incorrect or faulty;
check the connections and see Appendix
C for cable requirements.
• The printer may be in ‘character dump
mode’ (see Section 5.1); cycle the
printer power ‘Off’ and ‘On’.
Erratic print (strange characters
instead of ticket formats are
printed):
• The printer may be in ‘hex dump
mode’; see Section 5.1.
• If using the serial interface port, check
the host and printer communications
settings; see Section 3.5.1.
The cutter fails to cut, but the
Fault Indicator remains off:
First verify the cutter has been detected by
printing a Configuration Ticket; see
Section 3.5.1:
• If the cutter has not been detected, call
for service; otherwise, verify that the
cut function has been selected in the
software program.