Filter
Top Products
24 ST/SV-3210 and ST/SV-3306
4.1 Stock ID Selections
The printer maintains a selection of 10 user modifiable stock setups.
Each setup defaults to a specific print width, start print position and
cut/tear position, where:
Ø The Print Width is the print distance
across the ticket.
Ø The Start of Print Position is the
distance, measured in inches, from the
TOF Sensor to printhead burnline.
Ø The Cut/Tear Position is the distance,
measured in inches, from the TOF
Sensor to the cut (if equipped) or tear
position of the printed ticket.
The Stock ID can be set using the
Operational Database Modification
procedure (see Section 4.3.1). As defined on
the following page, Stock ID numbers 0
through 8 are not changeable through host
commands; however, Stock ID 9 will allow
host commands to override the default
settings.
If none of the listed Stock ID selections fit your media, select the Stock
ID that is closest to the physical dimensions of your stock and then
modify the Start of Print and Cut/Tear positions (see Section 4.2). All
changes can be saved to the Stock ID, allowing commonly used formats
to be recalled. To revert to the default values, reset the printer (see
Section 3.6).