Filter
Top Products
ConnectX®-3 Dual Port 40Gb/s and 56Gb/s Mezzanine Card for Dell User Manual Rev 1.0
Mellanox Technologies
27
number. Please contact Mellanox System Support if you cannot find the firmware binary for your
mezzanine card.
The following steps describe how to retrieve the PSID (firmware identification) and programmed
firmware version of your mezzanine card. They also describe how to update the card with the lat
-
est firmware version available.
1. Retrieve the PSID and firmware version:
a. Install the MFT package. The package is available at www.mellanox.com => Products =>
Software/Drivers => InfiniBand & VPI Software/Drivers => Firmware Tools. Make sure to
download the package corresponding to your computer’s operating system.
b. Enter: mst start
c. Get the Mellanox mst device name using the command "mst status". The mst device name will be of
the form: /dev/mst/mt4099_pci_cr0
d. Get the PSID (firmware identification) and programmed firmware version using the command
2. Compare the programmed firmware version with the latest available.
a. Go to Mellanox’s web site: http://www.mellanox.com/supportdownloader. See Figure 15
b. Enter your card PSID to display the latest firmware
> flint -d /dev/mst/mt4099_pci_cr0 q
Image type: ConnectX
FW Version: 2.9.4000
Device ID: 4099
Chip Revision: 0
Description: Node Port1
Port2 Sys image
GUIDs: 000002c900000200 000002c900000201
000002c900000202 000002c900000203
MACs:
000002c90200 000002c90201
Board ID: (MT_1020110019)
VSD:
PSID: MT_1020110019