Filter
Top Products
Replacing the Hard Drive
1. Slide the hard drive bezel onto the hard drive, then tighten the two M3 x 3-mm screws to secure the bezel to the drive.
2. Slide the hard drive into the hard drive bay until the drive is fully seated.
3. Replace the four M3 x 3-mm screws to secure the hard drive.
4. Install the operating system for your computer, as needed (see "Restoring Your Operating System" in your Owner's Manual).
5. Install the drivers and utilities for your computer, as needed (see "Reinstalling Drivers and Utilities" in your Owner's Manual).
Back to Contents Page
1
hard drive bezel
2
M3 x 3-mm screws (2)
3
hard drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: Hard drives are extremely fragile. Exercise care when handling the hard drive.
NOTICE: Use firm and even pressure to slide the hard drive into place. Excessive force may result in damage to the connector.