Filter
Top Products
8. Disconnect the display cable from the connector.
9. Disconnect the camera cable from the connector.
10. Pull the antenna cables from the routing hole and release them from the routing channel.
11. Remove the four screws from the display assembly hinges.
12. Lift the display assembly out of the computer.
Replacing the Display Assembly
1. Follow the instructions in Before You Begin.
2. Align the display hinges with the holes in the base of the computer, then lower the display into place.
3. Replace and tighten the four display assembly hinge screws.
4. Slide the antenna cables through the routing hole to the base of the computer.
5. Replace the display cable, camera cable and antenna cables in their proper routing guides.
1
display cable
2
camera cable
1
display assembly
2
antenna cables
3
camera cable
4
display cable
5
Hinge screws (4)
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.