Filter
Top Products
Back to Contents Page
System Board
Dell™Latitude™2100ServiceManual
Removing the System Board
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the battery from the computer.
3. Remove the keyboard from the computer.
4. Remove the access panel from the computer.
5. Remove the display assembly from the computer.
6. Open the clip that secures the touch pad cable to the system board.
7. Disconnect the touch pad cable from the system board.
8. Open the clip that secures the button board data cable to the system board.
9. Disconnect the button board data cable from the system board.
10. Turn over the computer.
11. Remove the six screws that secure the system board to the computer chassis.
12. Identify the side of the system board with USB ports attached, then lift that side of the system board from the chassis. Next, remove the system board
from the chassis and set it aside on a flat, clean surface.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe Flash Player from Adobe.com in order to view the illustrations below.