Filter
Top Products
Installation: Dell 2300MP Projector
file:///C|/Venkat%20Shared/Projectors/2300MP/EN/install.htm[11/30/2012 2:18:55 PM]
1 Power button
2 Lens cap
Powering Off the Projector
DO NOT UNPLUG THE PROJECTOR BEFORE PROPERLY SHUTTING DOWN USING THE FOLLOWING STEPS.
Powering off procedures
1. Press the power button to turn off the projector.
2. Press the power button again. The cooling fans continue to operate for 90 seconds.
3. If the LAMP light is solid orange, replace the lamp.
4. If the TEMP light is solid orange, the projector has overheated. The display automatically shuts down. Turn the
display on again after the projector cools down. If the problem persists, contact Dell
.
5. If the TEMP light is blinking orange, a projector fan has failed and the projector will automatically shut down. If
this problem persists, contact Dell
.
6. Disconnect the power cord from the electrical outlet and the projector.
7. If you press the power button while the projector is running, the "Power Off the Lamp?" message
appears on the screen. To clear the message, press any button on the control panel or ignore the message;
the message will disappear after 5 seconds.
Adjusting the Projected Image
Adjusting the Projector Height
To raise the projector:
1. Press the elevator button.
2. Raise the projector to the desired display angle, and then release the button to lock the elevator foot into
position.