Dell 2408WFP Computer Monitor User Manual


  Open as PDF
of 41
 
Using the OSD Menu
1. Push the MENU button to launch the OSD menu and display the main menu.
Main Menu for Analog (VGA) Input

B
PIP/PBP Select
Use this button to activate PIP (Picture-in-Picture)/PBP (Picture-by-Picture)modesadjustment.
Pressing this button continually cycles the monitor through the following modes : OFF-->PIP--
>PBP. You will see the following messages
corresponding to the mode selected.
→
→
C
OSD Menu/Select
The Menu button is used to open and exit the on-screen display (OSD), and exit from menus and sub-menus. See
Using the OSD Menu
D
Brightness /Contrast
Hot Key
Use this button for direct access to the "Brightness" and "Contrast" control menu.
D
and
E
Down (-) and Up (+)
Use these buttons to adjust (decrease/increase ranges) items in the OSD menu.
E
Auto Adjust
Use this button to activate automatic setup and adjustment. The following dialog appears on a black screen as the monitor self
the current input:
Auto Adjustment button allows the monitor to self-
adjust to the incoming video signal. After using Auto Adjustment, you can further
tune your monitor by using the Pixel Clock (Coarse), Phase (Fine) controls in the OSD.
NOTE: Auto Adjust does not occur if you press the button while there are no active video input signals or attached cables.
F
Power button
(withpowerlight
indicator)
Usethepowerbuttontoturnthemonitoronandoff.
Thegreenlightindicatesthemonitorisonandfullyfunctional.Anamberlightindicatespowersavemode.
NOTE: Ifyouchangethesettingsandtheneitherproceedtoanothermenu,orexittheOSDmenu,themonitor
automaticallysavesthosechanges.Thechangesarealsosavedifyouchangethesettingsandthenwaitforthe
OSD menu to disappear.
 previous next