Dell 320-4687 Computer Monitor User Manual


  Open as PDF
of 43
 



See Solving Problems for more information.
message:
This means that the monitor cannot synchronize with the signal that it is receiving from the
computer.Eitherthesignalistoohighortoolowforthemonitortouse.SeeMonitor
SpecificationsfortheHorizontalandVerticalfrequencyrangesaddressablebythismonitor.
Recommended mode is 1600 X 1200 @ 60Hz.
YouwillseethefollowingmessagebeforetheDDC/CIfunctionisdisabled.
When monitor get into Power Save mode, one of the following messages will appear
depending upon the selected input.
Activate the computer and wake up the monitor to gain access to the OSD
If either VGA or DVI-D input is selected and both VGA and DVI-D cables are not connected, a floating dialog box as shown below will appear.
or

When the monitor does not sense the selected video input, one of the following messages will appear depending upon the selected input as long as you press
anybuttonotherthanpowerbutton.
VGA / DVI-D input
Video Input
or
Occasionally, no warning message appears, but the screen is blank: this could also indicate that the monitor is not synchronizing with the computer or the
monitor is in a power save mode.
In PIP mode, when the monitor does not sense the selected second signal input, one of the following messages will appear depending upon the selected
input as long as the OSD screen is closed.
1.VGA
2. DVI-D
3. S-Video
4.Composite

or


or

or
NOTE:
When the cable is connected back to the input of the monitor, any active PIP window will disappear. Please enter PIP submenu to bring back the PIP window.
 previous next