Filter
Top Products
Installation 9
Connecting to a Terminal
1
Connect an RS-232 crossover cable to the ASCII terminal or the serial connector of a desktop system
running terminal emulation software.
2
Connect the female DB-9 connector at the other end of the cable to the device serial port connector.
NOTE: Do not connect the power cable to a grounded AC outlet at this time. You have to connect the device
to a power source in the steps detailed in Starting and Configuring the Device section.
Figure 1-3. Back-Panel Power Connector
Console Port
RPS Connector
Power Connector
PowerConnect 3524/3548 Rear View
Console Port
EPS Connector
Power Connector
PowerConnect 3524P/3548P Rear View