Filter
Top Products
66 Adding Parts
www.dell.com | support.dell.com
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions on page 7.
CAUTION: To guard against electrical shock, always unplug your
computer from the electrical outlet before opening the cover.
The computer’s card connectors allow you to install different types of
devices such as modems and network adapters.
1 Shut down the computer (see page 22).
2 Turn off any attached devices and disconnect them from their
electrical outlets.
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network wall jack.
3
Disconnect the computer power cable from the wall outlet, and then
press the power button to ground the system board.
4 Remove the computer stand, if it is attached (see page 16).
5 Open the computer cover (see page 62).
6 Remove the card cage:
a Check any cables connected to cards through the back-panel
openings. Disconnect any cables that will not reach the card cage
once it is removed from the computer.