Filter
Top Products
8. Disconnect the touch pad connector and the standby switch connector from the system board.
9. Lift the palm rest and remove it from the computer.
Replacing the Palm Rest
1. Align the palm rest with the bottom plastics and gently snap it into place.
2. Reconnect the touch-pad connector and the standby switch connector to the system board.
3. Tighten the palm -rest captive screw.
4. Turn the computer upside-down, and replace the eleven M2.5 x 8-mm screws on the bottom of the computer.
5. Replace the display assembly (see Replacing the Display Assembly).
6. Replace the keyboard (see Keyboard).
7. Replace the hinge cover (see Replacing the Hinge Cover).
Back to Contents Page
1
standby switch connector
2
touch pad connector