Filter
Top Products
Deploying the Dell PowerConnect 8100 with the Cisco Catalyst
10
console(config)# interface range te1/0/47-48
console(config-if)#channel-group 1 mode active
console(config-if)#no shut
console(config-if)#exit
console(config)#po1
console(config-if-Po1)#switchport mode trunk
console(config-if-Po1)#switchport trunk allowed vlan 100,101
console(config-if-Po1)#no shut
console(config-if-Po1)#exit
OR using general Mode changing only the configuration for Po1
console(config)#po1
console(config-if-Po1)#switchport mode general
console(config-if-Po1)#switchport general allowed vlan add 100,101
tagged
console(config-if-Po1)#no shut
console(config-if-Po1)#exit
Cisco Catalyst CLI
Here are the commands to run on the Cisco Catalyst
6504:
Cat6504E_1#configure terminal
Cat6504E_1(config)#vlan 100,101
Cat6504E_1(config-vlan)#exit
Cat6504E_1(config)#interface range te2/1-2
Cat6504E_1(config-if-range)#switchport
Cat6504E_1(config-if-range)#channel-group
1 mode active
Cat6504E_1(config-if-range)#exit
Cat6504E_1(config)#interface po1
Cat6504E_1(config-if)#switchport
Cat6504E_1(config-if)#switchport trunk encapsulation dot1q
Cat6504E_1(config-if)#switchport trunk allowed vlan 100,101
Cat6504E_1(config-if)#switchport mode trunk
Cat6504E_1(config-if)#no shutdown
Cat6504E_1(config-if)#exit