Filter
Top Products
Deploying the Dell PowerConnect 8100 with the Cisco Catalyst
9
VLAN configuration example
The following topology overview is an example of a much abbreviated network configuration between
two (2) end-user systems, the campus switch, and the core.
Example of access, and trunk VLANs
Figure 6.
Dell PowerConnect 8100 CLI
Run the commands below on the Dell PowerConnect 8100 switch to create an access mode switchport
going to a client (or edge) device. Then create a 2-port LACP LAG with a trunk mode switchport
carrying VLANs between it and the Cisco Catalyst 6504.
console#configure
console(config)#vlan 100, 101
console(config-vlan)#exit
console(config)#interface te1/0/1
console(config-if-Te1/0/1)#switchport access vlan 100
console(config-if-Te1/0/1)#exit
console(config)#interface te1/0/2
console(config-if-Te1/0/1)#switchport access vlan 101
console(config-if-Te1/0/1)#exit