Filter
Top Products
- 2 -
GETTING STARTED
1.Setting up the monitor
1.1 Take out the monitor, stand and monitor base from the package.
1.2 Place the monitor base on the desk and then slide the neck
into the slots of base. (Make sure the direction of the neck is
correct.)
1.3 Hold the monitor and then slide the monitor into the neck. (Make
sure the direction of the neck is correct)
2.Connecting signal cable
2.1 Switch off your computer
2.2 Connect the signal cable to the D-SUB port at the rear of
the monitor and tighten the connector screws
2.3 Connect the other end of signal cable to the computer's
VGA port and tighten the connector screws.
2.4 Note: Ensure the display setting does not exceed
1366 X 768 @ 60Hz.
Monitor installation
Package contents
Before beginning, ensure that the carton contains the following items:
1. LCD Monitor
2. Monitor Base and Neck
(the shape of base may vary according to the monitor model)
3. Power Cord (plug may vary according to the electrical standards
for your area)
4. Analog Signal Cable
3.Connecting power
Connect one end of the power cable to the monitor and
the other end to a power outlet.
4.Switching on
Switch on your computer.
You should now be able to see the picture. If not, see the
troubleshooting section of this guide.
5. CD-ROM (contains user manual)
6 .Quick Installation Guide
POWER D-SUB