Filter
Top Products
Removing and Installing Parts 137
7
Tighten the two screws to secure the floppy drive.
8
Attach the power and data cables to the floppy drive.
9
Connect the other end of the data cable to the connector labeled
"FLOPPY" on the system board (see "System Board Components" on
page 106) and route the cable through the clip on the shroud.
10
Check all cable connections, and fold cables out of the way to avoid
blocking airflow between the fan and cooling vents.
11
Replace the bezel (see "Replacing the Bezel" on page 125).
1 floppy drive 2 data cable 3 power cable
4 system board
connector
5 screws (2) 6 screw holes in the
floppy drive
2
4
3
1
5
6
book.book Page 137 Thursday, June 14, 2007 6:23 PM