Filter
Top Products
Using Your Projector 31
Management Menu
MENU LOCATION—Select the location of the
OSD on the screen.
P
ROJECTION MODE—Select how the image
appears:
• Front Projection-Desktop (the default).
• Rear Projection-Desktop-- The projector
reverses the image so you can project from
behind a translucent screen.
• Front Projection-Ceiling Mount-- The
projector turns the image upside down for
ceiling-mounted projection.
• Rear Projection-Ceiling Mount-- The
projector reverses and turns the image upside
down. You can project from behind a
translucent screen with a ceiling-mounted
projection.
SIGNAL TYPE—Show signal type RGB, YCbCr,
YPbPr.
L
AMP HOUR—Display the operating hours
since the lamp timer reset.
L
AMP RESET—After you install a new lamp,
select Yes to reset the lamp timer.
P
OWER SAVING—Select Yes to set the power saving delay period. The delay period is
the amount of time you want the projector to wait without signal input. After that
set time, the projector enters power saving mode and turns off the lamp. The
projector turns back on when it detects an input signal or you press the power
button. After two hours, the projector turns off and you need to press the power
button to turn the projector on.
OSD L
OCK—
Select
Yes
to enable
OSD Lock
for hiding the OSD menu. (Or
pressing the Menu button on control for 15 seconds), and select
No
to
disable the
OSD Lock
for hiding the OSD menu. (Or pressing the Menu
button on control for 15 seconds again).
RF_CH LEARNING—
Refer to page 36.
ECO MODE—Select On to use the projector at a lower power level (250 Watts),
which may provide longer lamp life, quieter operating and dimmer luminance
output on the screen. Select Off to operate at normal power level (300 Watts).