Filter
Top Products
42 Installing Enclosure Components
Control Panel
Removing the Control Panel
1
Turn off the enclosure and host server.
2
Disconnect all the power cables connected to the enclosure.
3
Remove the hard drives from:
– slots 0 to 2 in
PowerVault MD1200
– slots 0 to 5 in
PowerVault MD1220
See "Removing a Hard Drive" on page 31.
NOTE: Mark each hard drive with it’s slot position as you remove it.
4
Slide the control panel out of the chassis after:
– Pushing the release tab toward the front of the enclosure in
PowerVault MD1200
. See Figure 3-11.
– Pulling the release pin toward the front of the enclosure in
PowerVault
MD1220
. See Figure 3-12.
book.book Page 42 Monday, December 7, 2009 4:51 PM