Filter
Top Products
Installing the System Board
1. Place the system board on the chassis.
2. Tighten the screws to secure the system board to the computer.
3. Connect the following cables to the system board:
a) WiFi-switch board
b) speaker
c) coin-cell battery
d) LVDS
4. Route the antenna cables through the routing channels.
5. Install the LVDS support bracket in its position in the computer.
6. Tighten the screws to secure the LVDS support bracket to the computer
7. Connect the power connector cable to the system board.
8. Install the:
a) ExpressCard cage
b) palmrest
c) processor
d) heat sink
e) modem card
f) WLAN card
g) keyboard
h) keyboard trim
i) bluetooth card
j) optical drive
k) hard drive
l) base cover
m) battery
9. Follow the procedures in
After Working Inside Your Computer
.
Removing the Modem Connector
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove:
a) battery
b) base cover
c) hard drive
d) bluetooth card
43