Filter
Top Products
3. Tighten the screws on both corners to secure the display assembly.
4. Route the antenna and the LVDS cables through the routing channel.
5. Connect the following cables to the computer:
a) LVDS
b) camera
6. Connect the LVDS support bracket in its position on the computer.
7. Tighten the screw to secure the support bracket to the computer.
8. Install:
a) base cover
b) battery
9. Follow the procedures in
After Working Inside Your Computer
.
Removing the Display Bezel
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove the battery.
3. Pry up the bottom edge of the display bezel.
4. Pry up the left, right and top edges of the display bezel.
5. Remove the display bezel from the display assembly.
48