Filter
Top Products
Installing the Heatsink
1. Place the heatsink into its original position on the computer.
2. Tighten the screws to secure the heatsink to the computer.
3. Install:
a) display assembly
b) display-hinge cover
c) palmrest
d) keyboard
e) keyboard trim
f) mSATA
g) base cover
h) battery
i) SD card
4. Follow the procedures in
After Working Inside Your Computer
.
Removing the Display Assembly
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove:
a) battery
b) SD card
c) base cover
d) keyboard
e) palmrest
3. Perform the following steps as shown in the illustration:
a) Disconnect the WLAN cable from the system board [1].
b) Unroute the WLAN cables from the slot [2].
c) Remove the screw that secures the heatsink to the computer.
4. Perform the following steps as shown in the illustration: Disconnect the antenna cables from the wireless solution.
a) Disconnect the LVDS cable from the system board [1].
b) Unroute the cable from the slot [2].
c) Remove the screws and pull the antenna cables from the holes on the base chassis that secure the display
assembly to the computer.
25