Filter
Top Products
3. Reinstall the CMC module and reattach any cables that were disconnected.
On a single CMC system, the SD card activates automatically. For redundant CMC module systems, initiate a
changeover to make the passive module active using the following steps:
a. Navigate to the Chassis page.
b. Click the Power Management tab.
c. Click the Control sub tab.
d. Select the Reset CMC (warm boot) button.
e. Click Apply.
The CMC automatically fails over to the redundant module, and that module now becomes active and displays a
solid blue status LED. The SD card activates automatically.
For information on configuration and usage of the FlexAddress feature, see the CMC User’s Guide at
support.dell.com/manuals.
Figure 45. Installing an SD Card in the CMC Module
1. SD card connector
2. SD card
iKVM Module
Removing An iKVM Module
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1. Disconnect the cables attached to the iKVM module.
2. Press in the release latch on the handle and rotate the handle away from the module front panel.
3. Slide the module out of the enclosure.
83