Filter
Top Products
3. Select the Setup tab. The Configuring I/O Modules Network Settings page is displayed.
4. Configure the switch for integration into your network.
– Select DHCP Mode Enabled if your network uses a DHCP server to assign IP addresses.
– If your network uses static IP addressing, enter an IP address, subnet mask and gateway.
5. Click Apply.
6. Click the Deploy sub-tab.
After all I/O modules have been configured and connected, the enclosure’s blades can be inserted and booted with full
network communication.
Brocade M6505 16 Gbps FC SAN I/O Module
The Brocade M6505 16 Gbps FC I/O module includes eight external fibre channel ports, 16 internal ports, and one serial
port with an RJ-45 connector. The external fibre channel ports operate at 4 Gbps, 8 Gbps, or 16 Gbps. Internal ports
support speeds of 8 Gbps and 16 Gbps.
NOTE: This module can be upgraded to 24 ports using a Ports on Demand (POD) license.
This fibre channel switch module supports hot-pluggable Small Form Factor Pluggable plus (SFP+) optical transceivers.
NOTE: To ensure proper functionality, use only SFPs provided with this module.
Figure 17. Brocade M6505 16 Gbps FC SAN I/O Module
1. fibre channel ports (8)
2. port LED indicators
3. server management status/indicator LED
4. power status LED
48