Filter
Top Products
Back to Contents Page
Display Assembly
Alienware®M11x R3 Service Manual
Removing the Display Assembly
Replacing the Display Assembly
Removing the Display Assembly
1. Follow the instructions in Before You Begin.
2. Remove the base cover (see Removing the Base Cover).
3. Remove the battery pack (see Removing the Battery Pack).
4. Follow the instructions from step 4 to step 6 in Removing the Hard Drive.
5. Remove the memory module(s) (see Removing the Memory Module(s)).
6. Disconnect the antenna cables from the Mini-Card(s).
7. Note the routing of the Mini-Card antenna cables and remove them from the routing guides on the computer base.
8. Turn the computer over and open the display as far as possible.
9. Remove the hinge cover (see Removing the Hinge Cover).
10. Remove the keyboard (see Removing the Keyboard).
11. Remove the palm rest assembly (see Removing the Palm Rest Assembly).
12. Pull the pull-tab to disconnect the display cable from the connector on the system board.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery Pack) before working inside the
computer.
1
Mini-Card antenna cables