Dell M11X R3 Computer Hardware User Manual


  Open as PDF
of 42
 
Back to Contents Page
Status Light Board
Alienware®M11x R3 Service Manual
Removing the Status Light Board
Replacing the Status Light Board
Removing the Status Light Board
1. Follow the instructions in Before You Begin.
2. Remove the base cover (see Removing the Base Cover).
3. Remove the battery pack (see Removing the Battery Pack).
4. Follow the instructions from step 4 to step 6 in Removing the Hard Drive.
5. Remove the memory module(s) (see Removing the Memory Module(s)).
6. Remove the hinge cover (see Removing the Hinge Cover).
7. Remove the keyboard (see Removing the Keyboard).
8. Remove the palm rest assembly (see Removing the Palm Rest Assembly).
9. Turn the palm rest assembly over.
10. Disconnect the speaker lights cable from the connector on the status light board.
11. Push the connector latch up and pull the pull-tab to disconnect the power board cable from the connector on the status light board.
12. Lift the connector latch and pull the pull-tab to disconnect the status light board cable from the connector on the status light board.
13. Remove the five screws that secure the status light board to the palm rest assembly.
14. Lift the status light board off the palm rest assembly.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery Pack) before working inside the
computer.
1
speaker lights cable connector
2
power board cable connector
3
status light board cable connector
 previous next