Filter
Top Products
1344 Configuration and Image File Commands
The following table lists and describes reserved keywords.
Default Configuration
This command has no default configuration.
Reserved
Keyword
Description
running-config Represents the current running configuration file.
startup-config Represents the startup configuration file.
startup-log Represents the startup syslog file. This can only be the source of a
copy operation.
operational-log Represents the operational syslog file. This can only be the source
of a copy operation.
script
scriptname
Represents a CLI script file.
image Represents the software image file. When "image" is the target of a
copy command, it refers to the backup image. When "image" is
the source of a copy command, it refers to the active image. If this
is destination, the file will be distributed to all units in the stack.
ftp: Source or destination URL for an FTP network server. The syntax
for this alias is ftp:
//ipaddr/filepath/filename image
.
tftp: Source or destination URL for a TFTP network server. The syntax
for this alias is tftp:[[
//location
]
/directory
]
/filename
. An out-of-
band IP address can be specified as described in the User
Guidelines.
xmodem: Source for the file from a serial connection that uses the Xmodem
protocol.
usb: Source or destination URL for a file on a mounted USB file
system. Sub-directories are not supported on USB devices.
flash: Source or destination URL for the switch flash-based file system.
backup-config Represents the backup configuration file.
unit Indicates which unit in the stack is the target of the copy
command.
2CSPC4.XModular-SWUM200.book Page 1344 Thursday, March 10, 2011 11:18 AM