Filter
Top Products
260 Adding and Replacing Parts
NOTICE: To connect a network cable, first plug the cable in to the network port or
device and then plug it in to the computer.
15
Connect your computer and devices to their electrical outlets, and turn
them on.
See the documentation that came with the drive for instructions on
installing any software required for drive operation.
16
Enter the system setup program (see
"System Setup
" on page 89) and
select the appropriate
USB for Flexbay
option.
17
Verify that your computer works correctly by running the Dell Diagnostics.
See "Dell Diagnostics" on page 136 for instructions.
Removing a Media Card Reader (Desktop Computer)
1
Follow the procedures in "Before You Begin" on page 151.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 153).
3
Remove the drive panel (see "Removing the Drive Panel" on page 233).
4
Disconnect the interface cable from the back of the Media Card Reader.
5
Disconnect the other end of the interface cable from the system board
connector labeled "USB." To locate the system board connector, see
"System Board Components" on page 28.