Filter
Top Products
Removing and Installing Parts 73
Connecting and Disconnecting Drive Cables
When removing an IDE drive data cable
, grasp the colored pull-tab and pull until the connector
detaches.
When connecting and disconnecting a serial ATA data cable
, hold the cable by the black connector at
each end.
Like IDE connectors, the serial ATA interface connectors are keyed for correct insertion; that is, a
notch or a missing pin on one connector matches a tab or a filled-in hole on the other connector.
Hard Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet
before removing the cover.
NOTICE: To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a
surface, such as a foam pad, that will sufficiently cushion it.
NOTICE: If you are replacing a hard drive that contains data you want to keep, back up your files before
you begin this procedure.
Check the documentation for the drive to verify that it is configured for your computer.
Removing a Hard Drive
1
Follow the procedures in "Before You Begin" on page 53."
2
Lay the computer on its side so that the system board is on the bottom of the inside of the
computer.
3
Remove the computer cover (see page 59).