Filter
Top Products
Back to Contents Page
Chassis Intrusion Switch
Dell™OptiPlex™XEServiceManual—Small Form Factor
Removing the Chassis Intrusion Switch
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the hard-drive assembly.
3. Disconnect the chassis intrusion-switch cable from the system board.
4. Slide the chassis intrusion switch out of its slot in the metal bracket, and push it down to remove it from the computer.
Replacing the Chassis Intrusion Switch
To replace the chassis intrusion switch, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.