Filter
Top Products
Supported Equipment Manual
•
March, 2006
1-1
Chapter 1 • Introduction
Release Notes
1. For the 7500W terminal only (not 7500S) in all emulations, setting the backlight
timer in the Timers tab to 5 seconds or more enables the backlight when the trigger
(or any key) is pressed.
2. For the 7500W terminal only (not 7500S) in all emulations, choosing
Spec 1 in
the Mode scrolling list box under the Alarm tab enables vibrate only, and choosing
Spec 2 enables vibrate and beep.
3. Denso 103: firmware version E001 is required. Denso 7500W: firmware version
SB06 or newer is required. Denso 7500S: latest firmware version 1.12 is required.
4. Denso 103: in all emulations, scanning of 2D barcodes of up to 500 characters is
supported.
Descriptions
The Denso BHT-7500 measures 203 mm H x 75 mm W x 50 mm T, and weighs
approximately 10.6 oz (300 g).
This terminal meets the environmental requirements of an
operating temperature of -5°C to 50°C and a drip-proof requirement of JIS drip-proof II.
The BHT-7500 terminal is powered by a Lithium-ion battery cartridge (not included).
Auxiliary functions include: clock, beeper, resume functions, low battery indication, and
remote wake-up function.
Additional features of this terminal are as follows:
• Controller Unit
o 32-bit RISC memory
o 8.5 MB memory (User's area: 6.5 MB)
Note: The Controller Unit is required for operation of the terminal.
• Display Unit
o backlight
o FSTN liquid crystal dot matrix display device
o 160x159 pixel display