Denso BHT-7500 Barcode Reader User Manual


 
Error Message Resolution Guide
Message Reason Solution Reference Tech Note
Error receiving host\nlist from Server; Bad Protocol detected. Usually a result of bad cabling, power or
faulty transceiver. Also, will receive this if
the Mobile Unit is in the wrong mode for
server operation.
---
Unexpected Server\ndata received; Bad Protocol detected. Usually a result of bad cabling, power or
faulty transceiver. Also, will receive this if
the Mobile Unit is in the wrong mode for
server operation.
---
Error starting\nhost application; Connected to the server but can
not connect to the distant end.
Configure the server handler to access the
host application.
---
Select Host or App; Need to choose your
Host/application destination.
User selection required. ---
Connecting...; Attempting to connect to the
Host/application.
Advisory message. ---
TCP Error\nReading IP
Address\nREBOOT MOBILE UNIT;
Mobile Unit missing Network IP
information.
Configure the Mobile Unit with the correct
network IP information.
---
Printer start error; Could not initialize the printer.
Cable or power issue with the printer. ---
Battery too low\nto print; Not enough power to print. Replace the battery with a fully recharged
battery.
---
Paper Feed Error\nFix Then Hit Enter; Paper in the printer is not ready. Replace the paper or rethread the paper in
the printer.
---
Printer Error\nPrint Ended; Can not print. Check cable, battery, communication
settings and paper in the printer.
---
Supported Equipment Manual
March, 2006
4-5