Filter
Top Products
RADIUS
26
Field Descriptions
Radius Client Network Interface
This drop-down list is populated with all of the Network Interfaces configured on this
particular IMG. It is the responsibility of the user to make sure the interface may
reach the particular server. If you are
Authentication Port
The port on the physical IMG that will be used to talk to the Authentication server.
Accounting Port
The port on the physical IMG that will be used to talk to the Accounting server.
RADIUS Server Debug Mode
Off (Default)
If Radius is configured and the RADIUS server becomes unavailable, the IMG
will not process incoming calls. This is most typically found when the IMG is
used to create CDRs. Since the absence of a RADIUS server results in un-
billable calls, the IMG has been designed to not process calls when RADIUS is
enabled. If this occurs the IMG will reject calls to the network with the
following cause values:
ISDN - Cause 41 - Temporary failure
SS7 - Cause 41 - Temporary failure
H.323 - Cause 41 - Temporary failure
SIP - 503 - Service Unavailable
On
When Debug Mode is On, calls will be completed whether the RADIUS server is
active or not. The IMG will not require authentication from the RADIUS server
to complete a call and no billing information will be logged.
This is most typically used when using RADIUS for debugging purposes
(tracking call failures, cause codes, etc). You can also choose this mode if you
wish the IMG to continue to process calls in an un-billed fashion if you prefer to
provide free service rather than no service.
Prepaid Support
Enable
The IMG will act on data received in RADIUS Authentication Response
messages that the Radius Server may send pertaining to prepaid application.
This will allow the IMG1010 to be used in a prepaid application environment.
Disable (default)
NOTE: Radius Prepaid Support Mode will be disabled if Radius Debug Mode is
enabled. The two modes cannot be enabled at the same time.