Filter
Top Products
3. Click OK
4. Go to Rules > IP Rules > Add > IPRule
5. Now enter:
• Name: HTTP-WAN-to-DMZ
• Action: SAT
• Service: http
• Source Interface: wan
• Destination Interface: dmz
• Source Network: all-nets
• Destination Network: wan_ip
• Translate: Select Destination IP
• New IP Address: 10.1.4.10
6. Click OK
7. Go to Rules > IP Rules > Add > IPRule
8. Now enter:
• Name: HTTP-WAN-to-DMZ
• Action: Allow
• Service: http
• Source Interface: wan
• Destination Interface: dmz
• Source Network: all-nets
• Destination Network: wan_ip
9. Click OK
4.7.4. Spanning Tree BPDU Support
NetDefendOS includes support for relaying the Bridge Protocol Data Units (BPDUs) across the
NetDefend Firewall. BPDU frames carry Spanning Tree Protocol (STP) messages between layer 2
switches in a network. STP allows the switches to understand the network topology and avoid the
occurrences of loops in the switching of packets.
The diagram below illustrates a situation where BPDU messages would occur if the administrator
enables the switches to run the STP protocol. Two NetDefend Firewalls are deployed in transparent
mode between the two sides of the network. The switches on either side of the firewall need to
communicate and require NetDefendOS to relay switch BPDU messages in order that packets do not
loop between the firewalls.
4.7.4. Spanning Tree BPDU Support Chapter 4. Routing
217