Filter
Top Products
31D-Link WBR-2310 User Manual
Section 3 - Configuration
Enter a name for the rule.
This is the port used to trigger the application. It
can be either a single port or a range of ports.
Select the protocol of the trigger port (TCP,
UDP, or ANY).
This is the port number on the WAN side that
will be used to access the application. You may
define a single port or a range of ports. You
can use a comma to add multiple ports or port
ranges.
Select the protocol of the firewall port (TCP,
UDP, or ANY).
The schedule of time when the Application Rule
will be enabled. The schedule may be set to
Always, which will allow the particular service
to always be enabled. You can create your own
times in the Tools > Schedules section.
Name:
Trigger Port:
Trigger Type:
Firewall Port:
Port Type:
Schedule:
Application Rules
Some applications require multiple connections, such as Internet gaming, video conferencing, Internet telephony and
others. These applications have difficulties working through NAT (Network Address Translation). Special Applications
makes some of these applications work with the WBR-2310. If you need to run applications that require multiple
connections, specify the port normally associated with an application in the “Trigger Port” field, select the protocol type
as TCP or UDP, then enter the firewall (public) ports associated with the trigger port to open them for inbound traffic.
The WBR-2310 provides some predefined applications in the table on the bottom of the web page. Select the application
you want to use and enable it.