Filter
Top Products
BEFORE YOU BEGIN
Please read this guide before installation. Make sure that you have all the
necessary information and equipment. Also check whether the existing
hardware/software firewalls are disabled.
CONNECTING DSA-3110 HOTSPOT EDITION TO
EXISTING NETWORK
1. Connect an Ethernet cable between any of Ethernet ports 4-7
located on the back panel of the device and the Ethernet port of
your PC or the hub (switch) of your network.
2. Connect the power cord to the power connector port on the back
panel of the device, then plug the power adapter into an electrical
outlet or power strip. The Power LED turns on indicating that the
device has been powered on.
Attention! Using a power supply with a different voltage rating than the
one included will cause damage and void the warranty for this product.
3. Check whether the LED of the Ethernet port to which you have just
connected the Ethernet cable is on. If the relevant LED is off,
please repeat steps 1-2 and check the Ethernet cable.
Note: All LAN1 ports of the DSA-3110 Hotspot Edition device are auto-
MDI/MDIX. So you can use a straight-through Ethernet cable as well as a
crossover-one.