Filter
Top Products
DSL-300 ADSL Modem User’s Guide
22
PPP Account Configuration
PPPoE and PPPoA accounts use different connection types, however the variables that are required for
configuration are the same. These variables are summarized in the table below.
Figure 10. PPPoE Account Configuration
The PPP Account Configuration menu presents the following user defined parameters:
Connection Type
Use this drop-down menu to change connection type used for your ADSL
service. PPPoE is the default connection type used for the Modem.
User Name
Type in the User Name used to identify your account.
Password
Type in the password used for authentication of your account.
Authentication
This is the protocol to log on your account. Choose chap (default) or pap
form the drop-down menu as instructed by your ISP.
Connect on Demand
When this function is enabled the Modem begin to negotiate the ADSL
connection as soon as it is restarted. If this function is disabled, it will be
necessary to access this menu and hit the Connect button each time you
want to establish the ADSL connection.
Idle Time
The default value of 0 will maintain a continuous ADSL connection. If you
change this value, the Modem will discontinue the ADSL connection if the
ADSL interface remains idle for the amount of time (in seconds) that you
specify here. A disconnection requires the modem to be reconnected using
the Connect button in order to reestablish the ADSL connection.
When you have entered or changed the Account Configuration information according to the instructions of your
ISP or ADSL service provider, click the OK button. You will be prompted to continue making configuration
changes to the Modem or to save the changes you just made and restart the Modem now. Select the appropriate
option and click OK.
PPP Information
PPP Information is read-only. The IP settings information listed here are the IP settings that identify your
account and are used to route data traffic to and from the Modem.