Filter
Top Products
Now connect the telephone cable to the ADSL port on
the back of the device. Connect the other end of the
cable to the telephone wall jack.
To Power Supply
To Computer
To Phone Jack
Please proceed to step to configure the DSL-302G.
ADSL Configuration
The Configuration Utility allows you to change the VPI/VCI settings of the DSL-302G to
connect to your ISP and also displays ADSL connection information. The DSL-302G
comes with a default VPI of “0” and a VCI of “35”. If your DSL service provider uses
different numbers, change these numbers on the modem to match those of your provider.
If you are unsure of the VPI/VCI numbers, check all documentation provided by your
DSL provider or contact them to get this necessary information. The DSL modem will not
work unless the VPI and VCI numbers exactly match those of your DSL provider. Follow
the steps below to change the VPI/VCI if necessary.
There should be a DSL-300 Family Configuration Utility icon on your desktop. (Alter-
nately, you can go to Start>Programs>D-Link DSL Family>DSL-300 Family Configura-
tion Utility) If it is not installed, please refer back to step 2 to install the Ethernet
Configuration Utility.
Double-Click on the icon.
When the utility is launched, it will
search for any DSL-302G on the
network and display them in the
table. If the modem does not
appear in a few seconds, click the
Discover button.
Note: If the ADSL Link LED does not glow green
within three minutes of it being connected,
check all your cable connections to make sure
they are correct and securely installed.
Click