Filter
Top Products
49
Replacing the Lamp
1.
Insert the power cord into the wall outlet
• The [STAND BY] indicator lights up when the main power is input-
ted.
2.
Press the [EXIT], [HIDE], [PRESET] buttons on the remote
control sequentially, then press VOL ª for 2 seconds or
more
• The [STAND BY] and [OPERATE] indicators alternately blink about
every approx. 3 seconds. After blinking stops, lamp time resets
and the projector returns to the stand-by state ([STAND BY] indi-
cator lights up).
Resetting the lamp time
After installing a new lamp, reset the lamp time counter inside the projector when this is done. A new count will start.
If the display of the accumulated lamp time has reached 2000 hours, the projector will not work (lamp does not light up) unless the
lamp time is reset.
To ensure the lamp time has been reset
The lamp time can be checked via the “Lamp time” item in the “Infor-
mation” menu. (☞ page 32, 33, 34, 40)
Caution for reset work
Reset the lamp time only when you have replaced the lamp.
Never reset it while the lamp is still in use, otherwise the approximate
standard for gauging replacement time may be inaccurate, lamp per-
formance may suffer and lamp blow-out may also occur.
QUICK ALIGN.
PC VIDEO
VOLUME
PRESET HIDE
ENTER
MENU EXIT
FREEZE
OPERATE
V-KEYSTONE H-KEYSTONE
SCREEN
DIGITAL
ZOOM
FOCUS
W
S
PRESET HIDE
EXIT
EXIT
PRESET
HIDE
VOL( )
Press as per normal
Press for 2 seconds or more
Press for
2 seconds
HX-1E_p41-49_En.p65 10/3/03, 6:11 PM49