Dukane MCC2 Tablet User Manual


 
7..Click on each of the tabs at the top (Apps, Music, Movies, TV shows, Books, Photos) and
select which type of files you will want to sync on this device. Click the Sync or Apply button.
8..Repeat Steps 2 – 7 with each iPad that will be used in this cart.
Ready to Sync
1..When all the iPad devices have been configured, you are ready to charge and sync your
tablets. Place each iPad in a slot in the cart. Plug each device in using the 30-pin Apple
connector connectors. Plug the cart into a wall outlet.
2..If the iPad devices are new, they should be fully charged before attempting to sync.
3..When ready to sync, connect one end of the USB cable into the USB port near the auxiliary
outlet and the other into a USB 2.0 port on your Mac or PC.
4. .iTunes will open and syncing will start automatically. Each iPad will be listed in iTunes
under the Device list on the left hand side of the screen. You could review the sync status
from master PC.
NOTE: Please keep in mind that identifying the devices and syncing will take time, so please
be patient. The time is dependent on the number of iPads being synced and the
amount of data being transferred. It can range from a few minutes to hours on 32
devices depends on different content. Please do not stop the process once it has been
started.
5..When syncing is complete, the Eject symbol will appear next to each device. At this time it
is safe to eject the device by clicking on the Eject symbol or closing iTunes.
6..When syncing is complete, unplug the USB Cable from your PC so charging can begin.
Charging will not occur while the USB Cable is plugged into the master laptop.
iOS Updates
Due to the functionality of the iTunes
software, iOS updates can not be done
across the whole fleet of iPads at one
time. This will need to be completed
one unit at a time. It can still be done
with the units plugged into the cart.
To update iOS on each iPad, select an
iPad from under the Device list on the
left side of the screen. Click on the
Update button in the middle of the
screen. Follow the prompts to
complete the update. Updating time
will vary depending on the size of the
update from Apple. When one unit is
complete, the next unit can be
selected until all units have been
updated.
WARNING :
This cart must only be used for its intended purpose in accordance with these
operating instructions. Failure to observe the following notices can result in fire, injury, death by
electric shock or equipment damage.
8
Safety
ELECTRIC SHOCK
Operate Carefully
Always turn the cart power OFF before plugging the power cord into
or removing from the wall outlet.
Make sure each devices is turned OFF before plugging into the cart.
Do not unplug this cart from the outlet when your hands are wet.
Do not use cables that are damaged.
Do not unplug by pulling on the cable.
Do not plug the power cord into an extension cable.
Keep the door closed and locked when in use.
Disconnect the power cord from the wall outlet before opening the doors.
Before moving this cart from one room to the next, wrap the power
cord around the winder located on the rear side of the cart.
This cart is not designed to be operated by a child or student. Only
Adult operation and supervision should move this cart.
Do not allow anyone to set, stand, or climb on the cart.
Move the cart slowly.
Keep the caster locked when the cart is not in transit.
Keep the cart away from water.
Keep the ventilation holes unblocked for air circulation.
Do not block the ventilation holes when charging.
Do not pull the cart. Push the cart using the ergonomic handles
to prevent muscle strain.
Do not place a TV or monitor on top of the cart.
Do not use the cart to store liquids or cleaning supplies.
Keep the door closed and locked when in use.
Disconnect the power cord from the wall before opening doors.
9