Filter
Top Products
When using your overhead projector, basic safety precautions should
always be followed, including the following:
1. Read and understand all instructions before using.
2. Close supervision is necessary when any projector is used by or near
children. Do not leave projector unattended while in use.
3. Care must be taken as burns can occur from touching hot parts.
4. Do not operate projector with a damaged cord or if the projector
has been dropped or damaged — until it has been examined by a
qualified service technician.
5. Position the cord so that it will not be tripped over, be pulled or
contact hot surfaces.
6. If an extension cord is necessary, a cord with a current rating at least
equal to that of the projector should be used. Cords rated for less
amperage than the projector may overheat.
7. Always unplug projector from electrical outlet before cleaning and
servicing and when not in use. Never yank cord to pull plug from
outlet. Grasp plug and pull to disconnect.
8. Let projector cool completely before putting away.
9. To protect against the risk of electric shock, do not immerse this
projector in water or other liquids.
10. To avoid the risk of electric shock, do not disassemble this projector,
but take it to a qualified service technician when some service or
repair work is required. Incorrect reassembly can cause electric
shock when the projector is used subsequently.
11.
The use of an accessory attachment not recommended by the manufac
-
turer may cause a risk of fire, electric shock or injury to persons.
12. Connect this projector to a grounded outlet.
13. Disconnect this unit from its source of supply before replacing the
projection lamp.
Additional lamp safeguards: never handle lamps with bare fingers; periodi-
cally inspect lamps, when they’re turned off, for signs of blistering or
blackening; insure proper action of the cooling system; turn off the
projector immediately if the image becomes abnormally dim; never
operate a projector with the lamp housing open; and make sure that the
lamp itself is properly seated.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS